Dell 4320 Projector - Manual (Page 51)

c After the setup is complete, press the button to exit.
3. After the IP Address, Subnet Mask, Gateway, and DNS is set up,
select Store and press button to store the settings.
4. If you select Store without pressing the Enter button, the system will
keep the original settings.
R ESET — Press to reset network configuration.
W IRELESS S ETTINGS — Select and press to activate wireless settings. The
wireless settings menu provides the following options:
W IRELESS — Default option is Connected. Select Disconnected to disable
the wireless connection.
NOTE: It is recommended to use the default settings for Wireless
Connect.
DHCP S ERVER — Allows you to enable DHCP server of the wireless.
S TART IP A DDRESS — Automatically or manually assigns the Start IP
address of the DHCP server to the projector connected to the wireless.
E ND IP A DDRESS — Automatically or manually assigns the End IP address of
the DHCP server to the projector connected to the wireless.
S UBNET M ASK — Configure the Subnet Mask of the wireless connection.
G
ATEWAY
— Check the Gateway address with your network/system
administrator if you configure it manually.
DNS— Check the DNS Server IP address with your network/system
administrator if you configure it manually.
S TORE — Press to save the changes made in wireless configuration
settings.
NOTE:
1. Use and buttons to select IP Address, Subnet Mask,
Gateway, DNS, and Store.
Using Your Projector 51