Dell Dimension 2300 - Manual (Page 91)

Appendix 91
1 Record all the screens in the system setup program (see page 87) so
that you can restore the correct settings when your perform step 7.
2 Open the computer cover (see page 67).
3 Locate the battery socket BATTERY (see page 70).
4 Remove the battery by carefully prying it out of its socket with your
fingers or with a blunt, nonconducting object such as a plastic
screwdriver.
NOTICE: To avoid damage to the system board while you pry the battery
loose, be sure to insert the plastic screwdriver between the battery and the
socket (not the system board).
5 Insert the new battery into the socket with the side labeled "+" facing
up and snap the battery into place.
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
6 Connect your computer and devices to electrical outlets, and turn
them on.
7 Access the system setup program (see page 87) and restore the settings
you recorded in step 1.
8 Properly dispose of the old battery (see page 12).
battery socket
(BATTERY)
battery