Battery latch assembly, Removing the battery latch assembly, Replacing the battery latch assembly – Dell Inspiron 1318 (Mid 2008) User Manual
Page 3
Back to Contents Page
Battery Latch Assembly
Dell™ Inspiron™ 1318 Service Manual
Removing the Battery Latch Assembly
Replacing the Battery Latch Assembly
Removing the Battery Latch Assembly
1.
Remove the system board (see
System Board
).
2.
Remove the charger board (see
Charger Board
).
3.
Press the plastic grip together to release the latch button.
4.
Slide the battery latch assembly to the right to remove it.
Replacing the Battery Latch Assembly
1.
Replace the spring and slide the battery latch assembly into place.
2.
Replace the latch button.
3.
Replace the charger board (see
Charger Board
).
4.
Replace the system board (see
System Board
).
5.
Slide the battery into the battery bay, until it clicks into place.
CAUTION:
Before performing the following procedures, follow the safety instructions shipped with your computer.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE:
Before you remove the battery release button, observe the orientation of the button to ensure proper installation when the button is
replaced.
1
latch assembly
2
plastic grip
NOTICE:
Ensure the battery latch assembly is properly oriented. The indent for the button should face up when installing the assembly.