Dell Dimension 2100 - Manual (Page 38)

Exit Screen
Table 12. Exit Screen Options
this option are Power On or Stays Off (default).
1st Boot Device Determines which device the computer tries to boot from first. Use the up- or down-arrow key to highlight a device. Settings for
this option are as follows:
l Floppy
l
ARMD FDD
l ARMD HDD
l IDE-HDD
l
ATAPI CD-ROM
l SCSI*
l Network*
l Disabled
*Where SCSI or Network is the name of the installed device.
2nd Boot
Device Determines which device the computer tries to boot from if it cannot boot from the device selected for 1st Boot Device.
Settings for this option are the same as those for 1st Boot Device except for NETWORK.
3rd Boot
Device Determines which device the computer tries to boot from if it cannot boot from the devices selected for 1st Boot Device and
2nd Boot Device. Settings for this option are the same as those for 1st Boot Device except for NETWORK and SCSI.
4th Boot Device Determines which device the computer tries to boot from if it cannot boot from the devices selected for 1st Boot Device, 2nd
Boot Device, and 3rd Boot Device. Settings for this option are the same as those for 1st Boot Device except for
NETWORK and SCSI.
Option Function
Exit Saving
Changes Saves any changes you have made, exits the system setup program, and restarts the computer.
Exit Discarding
Changes Discards any changes you have made, exits the system setup program, and restarts the computer.
Load Setup
Defaults Discards any changes you have made and reverts all options to their defaults, but does not exit the system setup program.
Load Custom
Defaults Loads any settings saved using the Save Custom Defaults option. Press <Enter>. Then press the spacebar to select
Yes or No at the confirmation pop-up menu, and press <Enter> again.
Save Custom
Defaults Saves any changes you have made, but does not exit the system setup program.
Discard Changes Discards any changes you have made and reverts all options to their last saved settings, but does not exit the system
setup program.