Dell Precision R5400 (Mid 2008) - Manual (Page 35)

Troubleshooting
35
M EMORY DATA LINE FAILURE AT ADDRESS , READ VALUE EXPECTING VALUE — A
memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them. See your
Service Manual at
support.dell.com for more information.
M EMORY DOUBLE WORD LOGIC FAILURE AT ADDRESS , READ VALUE EXPECTING
VALUE — A memory module may be faulty or improperly seated. Reinstall the
memory modules and, if necessary, replace them. See your Service Manual at
support.dell.com for more information.
M EMORY ODD / EVEN LOGIC FAILURE AT ADDRESS , READ VALUE EXPECTING
VALUE — A memory module may be faulty or improperly seated. Reinstall the
memory modules and, if necessary, replace them. See your Service Manual at
support.dell.com for more information.
M EMORY WRITE / READ FAILURE AT ADDRESS , READ VALUE EXPECTING VALUE — A
memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them. See your
Service Manual at
support.dell.com for more information.
N O BOOT DEVICE AVAILABLE — The computer cannot find the hard drive. If
the hard drive is your boot device, ensure that the drive is installed, properly
seated, and partitioned as a boot device.
N O BOOT SECTOR ON HARD DRIVE — The operating system may be corrupted.
Contact Dell (see "Contacting Dell" on page 71).
N O TIMER TICK INTERRUPT — A chip on the system board may be
malfunctioning. Run the System Set tests in the Dell Diagnostics (see "Dell
Diagnostics" on page 39).
N OT ENOUGH MEMORY OR RESOURCES . E XIT SOME PROGRAMS AND TRY AGAIN —
You have too many programs open. Close all windows and open the program
that you want to use.
O PERATING SYSTEM NOT FOUND — Reinstall the hard drive (see your Service
Manual at support.dell.com). If the problem persists, contact Dell (see
"Contacting Dell" on page 71).
O PTIONAL R O M BAD CHECKSUM — The optional ROM has failed. Contact
Dell (see "Contacting Dell" on page 71).
A REQUIRED . D L L FILE WAS NOT FOUND — The program that you are trying to
open is missing an essential file. Remove and then reinstall the program.