Dell Latitude C800 - Manual (Page 31)

Removing and Replacing Parts 29
F le x C ab l e
2 Remove the 6-mm screw that secures the display flex cable to the
strain relief, and then use the pull loop to remove the display flex cable
from the graphics card.
NOTICE: When reconnecting the flex cable, press down on both ends of the
connector, not in the middle. Pressing the middle of the connector can damage
fragile components.
3 Open the display and, from the back of the computer, remove the two
screws labeled with a “circle D” that secure the display assembly to the
bottom case assembly.
4 With the display in an upright position, lift the display assembly from
the bottom case assembly.
6-mm screw
strain relief
pull loop
flex cable
64mcwc11.book Page 29 Tuesday, April 3, 2001 9:58 AM