Dell Latitude C800 - Manual (Page 56)

54 Remo ving and Replacing Parts
w
w
w
.d
e
ll.c
o
m
|
s
u
p
p
o
rt
.d
e
ll.
c
o
m To replace a connector cover, orient the cover notch-side-up and snap it into
the connector cutout.
R J -1 1 /R J - 45 Bo a r d
Removing the RJ-11/RJ-45 Board
1 Follow the instructions in “Preparing to Work Inside the Computer .”
2 Remove the system board .
3 Remove the 4-mm screw from the RJ-11/RJ-45 board.
NOTICE: The plastic tab is fragile; pull it back only far enough to remove the
board assembly.
4 Reach into the enclosure and, while pulling the tall plastic tab away
from the board assembly to release it, lift out the assembly.
When replacing the RJ-11/RJ-45 board assembly, protect the wiring harness
by routing it between the plastic posts.
4-mm screw
64mcwc11.book Page 54 Tuesday, April 3, 2001 9:58 AM