Dell Dimension 2010 - Manual (Page 32)

32 Drives
CAUTION: Ensure that you do not scratch the screw holes with the screwdriver
as the hard disk circuit board assembly is exposed here.
4 Place the computer in an upright position.
5 Remove the four screws that secure the hard drive to the hard drive bay.
6 Slide the hard drive out towards the back of the computer.
7 If removing the hard drive changes the drive configuration, ensure that you
reflect these changes in system setup (see "System Setup" on page 69).
1 power cable 2 data cable 3 screws (4)
3
2
1
book.book Page 32 Monday, November 19, 2012 11:42 AM