Dell Dimension 2010 - Manual (Page 45)

Power Switch Module 45
8 Slide the holder along with the hard drive activity light and cable out
through the front of the computer.
Replacing the Power Switch Module
1 Slide the power switch module through the slot on the front panel.
2 Press the holder and gently snap it into the front panel until it clicks into
place.
3 Gently push the hard drive activity light into its holder.
4 Connect the power switch module cable to the power switch module
connector (FP1) on the system board.
5 Replace the hard drive (see "Replacing a Hard Drive" on page 33).
6 Replace the front bezel (see "Replacing the Front Bezel" on page 20).
7 Replace the computer cover on both the sides (see "Replacing the
Computer Cover" on page 16).
book.book Page 45 Monday, November 19, 2012 11:42 AM