Dell XPS M1210 (MXC062, Mid 2006) - Manual (Page 28)

Thermal-Cooling Assembly: Dell XPS M1210 Service Manual
file:///C|/Users/santhosh_v.ASIA-PACIFIC/Desktop/Hawke/New%20folder/coolass.htm[2/21/2014 11:14:54 AM]
1 mylar tape 2 captive screws (4) 3 thermal-
cooling
assembly
4 captive screw (1) (present only on
computers with discrete video)
5 securing loop (present only on
computers with discrete video)
Replacing the Thermal-Cooling Assembly
1. If you are installing a new thermal-cooling assembly, place new thermal pads on the thermal-cooling assembly, or if
you are installing a new processor, place a new thermal pad on the thermal-cooling assembly at the point that covers
the processor:
a. Remove the backing from the new thermal pad, taking care not to tear the pad.
NOTE: You can place the new thermal pads directly on any existing thermal pads already installed on the thermal-
cooling assembly. It is not necessary to remove an existing pad or to clean the surface.
b. On the underside of the thermal-cooling assembly, place the thermal pad(s)' adhesive-side on top of the old
pad, and press it into place.
1 thermal pads (3) 2 underside of thermal-cooling assembly