Dell XPS M1210 (MXC062, Mid 2006) - Manual (Page 51)

Display : Dell XPS M1210 Service Manual
file:///C|/Users/santhosh_v.ASIA-PACIFIC/Desktop/Hawke/New%20folder/display.htm[2/21/2014 11:15:04 AM]
5. Reconnect the camera connector (if an optional camera is present).
6. Replace the M2 x 3-mm ground screw that attaches the display-panel ground wire to the display back cover.
7. Replace the four M2 x 3-mm screws (two on each side) that connect the display panel to the display back cover.
8. Replace the display bezel (see Replacing the Display Bezel ).
Display-Panel Brackets
Removing the Display-Panel Brackets
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product
Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an
unpainted metal surface (such as the back panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your
Computer ) before working inside the computer.
1. Follow the instructions in Before Working Inside Your Computer .
2. Remove the display assembly (see Removing the Display Assembly ).
3. Remove the display bezel (see Removing the Display Bezel ).
4. Remove the display panel (see Removing the Display Panel ).
5. Remove the four M2 x 3-mm screws (two on each side) that attach the two display-panel brackets to the display
panel.
1 display panel 3 M2 x 3-mm screws (4)
2 display-panel brackets (2) 4 tabs on display-panel brackets (4)
Replacing the Display-Panel Brackets
NOTICE: Ensure that you attach the display-panel brackets to the display panel such that the tabs are flush with the
display panel surface.