Module cover, Removing the module cover, Replacing the module cover – Dell Inspiron 15z (1570, Mid 2009) User Manual
Page 2
Back to Contents Page
Module Cover
Dell™ Inspiron™ 1470/1570 Service Manual
Removing the Module Cover
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Loosen the captive screw on the module cover.
4.
Lift the module cover up at an angle to carefully disengage it from the computer base.
Replacing the Module Cover
1.
Align the tabs on the module cover with the slots on the computer base and gently snap the cover into place.
2.
Tighten the captive screw that secures the module cover to the computer base.
3.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the back panel) on the computer.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
NOTE:
The location of the screw on the module cover may vary depending on the model of your computer.
1
module cover tabs (2)
2
module cover
3
captive screw