Before you begin, Recommended tools, Turning off your computer – Dell Inspiron 15z (1570, Mid 2009) User Manual

Page 4: Before working inside your computer

Advertising
background image

Back to Contents Page

 

Before You Begin

Dell™ Inspiron™ 1470/1570 Service Manual 

  

Recommended Tools

  

Turning Off Your Computer

  

Before Working Inside Your Computer


This manual provides procedures for removing and installing components in your computer. Unless otherwise noted, each procedure assumes that the
following conditions exist:

l

 

You have performed the steps in

Turning Off Your Computer

and

Before Working Inside Your Computer

.

l

 

You have read the safety information that shipped with your computer.

l

 

A component can be replaced or—if purchased separately—installed by performing the removal procedure in the reverse order.

 

Recommended Tools

The procedures in this document may require the following tools:

l

 

Phillips screwdriver

l

 

small flat-blade screwdriver

l

 

plastic scribe

l

 

BIOS executable update program available at support.dell.com

 

Turning Off Your Computer

 

 

1.

Save and close all open files and exit all open programs.

 

2.

In Windows Vista

®

, click

®

® Shut Down.

In Windows

®

7, click

® Shut Down.

The computer turns off after the operating system shuts down.

 

3.

Ensure that the computer is turned off. If your computer did not automatically turn off when you shut down the operating system, press and hold the
power button until it turns off.

 

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.

 

 

 

 

 

 

NOTE:

This manual provides instructions for servicing the Inspiron 1470 and Inspiron 1570 computers. The majority of the instructions are the same for

both computers, however your model may vary slightly in appearance.

CAUTION:

To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

CAUTION:

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is

not covered by your warranty.

CAUTION:

Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal

mounting bracket. Hold a component such as a processor by its edges, not by its pins.

CAUTION:

When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking

tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.

Advertising