Palm rest assembly, Removing and replacing the palm rests, Removing the palm rest assembly – Dell Inspiron 8100 User Manual
Page 30
Palm Rest Assembly
Removing and Replacing the Palm Rests
1.
If the computer is connected (docked) to an advanced port replicator (APR), undock it.
2.
Keep the display open, and tilt the computer back so that you can access the bottom of the computer.
3.
Slide and hold the latch release on the left side, and remove any device installed in the media bay.
4.
Slide and hold the latch release on the right side, and remove any battery installed in the battery bay.
5.
Locate the indentation under each palm rest, place your thumbs on the indentation, and gently push to release the palm rests.
6.
Remove the palm rests.
7.
To replace a palm rest, insert it into the slots on the computer. Then press along the outside edges of the palm rest until it snaps into place.
Repeat the process on each side.
Removing the Palm Rest Assembly