Fan assembly, Removing the led board, Replacing the led board – Dell Inspiron 8100 User Manual
Page 36: Removing the fan assembly
Removing the LED Board
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
3.
Remove the two M2 x 4-mm screws.
4.
Pull the LED board away from its connector.
Replacing the LED Board
1.
Align the two screw holes with the two mounting holes on the bottom case assembly, and press the board into its connector.
2.
Replace the two M2 x 4-mm screws.
Fan Assembly
Removing the Fan Assembly
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
.
NOTICE:
Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface on the computer.
NOTICE:
Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface on the computer.