Dell Precision 610 User Manual
Page 102
cards.
the Cancel button if the ICU does not display a
message naming the conflicting card.
3.
Repeat step 2 until the ICU displays a message
box naming the conflicting card and the
resource(s) in conflict. See the following table
entry for an explanation of this message box.
This device is unconfigurable
because of a resource conflict with
card card_name. The conflicting
resource is resource_name. To fix,
reconfigure the conflicting card.
The selected card is
unconfigurable because one of
its resources is already being
used by another device.
Perform the following procedure:
1. Make a note of the card name and the type of
conflicting resource.
2.
Follow the procedure in "
" and
change the value for resource_name used by
card_name.
The ICU has successfully
configured all Plug and Play cards
in your system. For the new
configuration to take effect, save
the configuration, then reboot your
system.
The ICU has successfully
configured all of the Plug and
Play expansion cards that were
not configured by the
Configuration Manager.
To accept these settings, save the configuration
information into NVRAM by selecting Exit from the File
menu and then selecting Yes to save. You must reboot
your system for these settings to take effect.
The loaded card is not a category
card. Press OK to proceed.
The category you have chosen
is not the correct category
under which to add this card.
Select OK. The ICU automatically opens the correct
category's dialog box. Continue the procedure for adding
the card as described in "
".
No more DMA values can be
added.
No more interrupt values can be
added.
No more memory values can be
added.
No more I/O port values can be
added.
No more values are available
for the resource you are trying
to add or modify.
The maximum number of values for each resource is as
follows:
4 DMA channels
7 IRQ lines
9 memory address blocks
20 I/O ports
To free values for the resource you are trying to add or
modify, delete some of the values listed in the resource
box for the card. If your card requires all of the values
listed, contact your card manufacturer to resolve the
issue.
The ICU detects
a resource conflict between this
card and conflicting_card.The
conflicting resource was: resource.
You added or modified a card
that now requires a resource
value
already in use by
conflicting_card.
Try each of the following options until the problem is
resolved:
Modify the card you are adding so that it uses a
different value for resource. See "
" for instructions.
Modify conflicting_card so that it uses a different
value for resource. See "
" for
instructions.
If conflicting_card is not the system board or
riser board, remove it from the computer. See
"
" for instructions.
Remove all expansion cards from the ICU, and
then add them back one at a time, beginning with
the new card and resolving resource conflicts as
they arise. See "
" and "
" or "
" for
instructions.