Dell Precision 610 - Manual (Page 24)

Primary SCSI and Secondary SCSI
SCSI controls the system's on-board primary and secondary small computer system interface (SCSI) controllers. The settings for
Primary SCSI and Secondary SCSI are:
Off (the default)
On
Refer to " Using the Integrated SCSI Controllers " and " Installing Drives " for information about configuring and installing SCSI
devices.
System Security
System Security configures the password and chassis intrusion settings. Press <Enter> to configure these settings.
System Password
System Password displays the current status of your system's password security feature and allows you to assign and verify a new
password. A new system password can be assigned only when the current status is either Not Enabled or Enabled, which is
displayed in bright characters.
The System Password option has the following settings:
Not Enabled (the default)
Enabled
Disabled by Jumper
NOTE: Read " Using the System Password Feature " for instructions on assigning a system password and using or
changing an existing system password. See " Disabling a Forgotten Password " for instructions on disabling a forgotten
system password.
Password Status
When Setup Password is set to Enabled, Password Status prevents the system password from being changed or disabled at
system start-up.
To lock the system password, you must first assign a setup password in the Setup Password option and then change the
Password Status setting to Locked. When the Setup Password feature has a password assigned and Password Status is set to
Locked, the system password cannot be changed through the System Password option and cannot be disabled at system start-up
by pressing <Ctrl><Enter>.
To unlock the system password, you must enter the setup password in the Setup Password option and then change the Password
Status setting to Unlocked. In this state, the system password can be disabled at system start-up by pressing <Ctrl><Enter> and
then changed through the System Password option.
Setup Password
Setup Password lets you restrict access to your computer's System Setup program in the same way that you restrict access to your
system with the system password feature. The options are:
Not Enabled (the default)
Enabled
Disabled by Jumper
NOTE: Read " Using the Setup Password Feature " for instructions on assigning a setup password and using or changing