Dell Precision 610 User Manual
Page 104
Message
Probable Cause
Corrective Action
Found Plug and Play ISA
card: Plug and Play ISA Card
Name.
This message appears
at system start-up for
each Plug and Play
ISA expansion card
recognized by the
Configuration Manager.
Status message; no action is required.
NOTICE: Boot Device Not
Active! CSN=Card Select
Number.
A boot device was
found to be inactive.
Status message; no action is required. The Configuration Manager
automatically configures and activates the device.
One or more active devices
have been reconfigured -
system requires reboot. Press
any key to reboot system.
You modified the
resource values of one
or more PCI or Plug
and Play ISA
expansion cards.
Reboot the system to reconfigure the card(s).
The Plug and Play ISA card
has been successfully
configured.
Card Count Plug and Play
ISA cards have been
successfully configured.
The Configuration
Manager ha
successfully configured
the given number of
cards.
If this message does not match the number of Plug and Play ISA
expansion cards installed in your computer, reinstall any Plug and
Play expansion cards not listed and reboot the system.
ERROR: Insufficient CM
Memory
There is not enough
memory available to
the Configuration
Manager for it to run.
Disable any TSR programs or any unneeded device drivers.
ERROR: Fatal BIOS
error Internal Error Code.
A BIOS call failed with
an internal error. The
most likely cause is an
incompatibility between
the BIOS and the
Configuration Manager.
See the chapter titled "Getting Help" in your Diagnostics and
Troubleshooting Guide for instructions on obtaining technical
assistance.
ERROR: Could not read NVS,
Error=Internal Error Code.
An attempt to read the
NVRAM failed.
See the chapter titled "Getting Help" in your Diagnostics and
Troubleshooting Guide for instructions on obtaining technical
assistance.
ERROR: Failed NVS write.
Error=Internal Error Code.
An attempt to write to
NVRAM failed.
Run the Dell Diagnostics to verify the integrity of your system
NVRAM. See the chapter titled "Running the Dell Diagnostics" in your
Diagnostics and Troubleshooting Guide for instructions. If you are
unable to determine the cause of the error, see the chapter titled
"Getting Help" in your Diagnostics and Troubleshooting Guide for
instructions on obtaining technical assistance.
ERROR: Failed to activate
device, CSN=Card Select
Number.
A Plug and Play
expansion card could
not be activated.
Use the following procedure:
1. Exit the ICU and turn off your system.
2. Remove the Plug and Play expansion card that could not be
activated.
Follow steps 2 through 5 of "
"
and then return to this procedure.
3.
Reinstall the Plug and Play expansion card.
Follow steps 4 through 8 of "
" and
then return to this procedure.