Dell PowerVault 124T - Manual (Page 18)

Connecting the SAS, Ethernet, and Power Cables
To connect the SAS, Ethernet, and power cables to the autoloader:
1. Shut down and turn off the selected server. Turn off all attached accessory devices, such as printers and other devices.
2. Attach one end of an Ethernet cable to the back panel of the autoloader.
3. Attach the other end of the Ethernet cable to the host computer or network.
4. Attach one end of the SAS cable (included in the accessory kit) to the SAS connector on the back panel of the autoloader.
5. Attach the other end of the SAS cable to the connector on the SAS host adapter.
If the supplied SAS cable does not fit the connector on your SAS host adapter, you either have an incompatible SAS host adapter or you need to
purchase a cable adapter. Contact your Dell service representative or go to
www.dell.com .
The following figure shows how to connect the SAS, Ethernet, and power cables:
1 SAS cable
2 Power cable
3 Getting Started Guide
4 CD (drivers and documentation)
5 Magazine blank (supplied only with a single magazine configuration)
6 Bar code labels
7 TORX L-key drivers (T8 and T10)
8 Emergency Magazine Removal Tool