Dell Latitude CPi A - Manual (Page 38)

30 Dell Latitude CPiA Service Manual
0RGXODU%D\'HYLFHV 'LVNHWWH'ULYH
&'520'ULYH%DWWHU\RU7UDYHO0RGXOH 
)LJXUH0RGXODU%D\'HYLFH5HPRYDO
NOTE: You do not need to remove the main battery or hard-disk drive prior to
this procedure.
&$87,21 0DNHVXUHWKHZRUNVXUIDFHLVFOHDQWRSUHYHQWVFUDWFKLQJ
WKHFRPSXWHUFRYHU
1. Close the display and turn the computer over.
2. Remove the device from the modular bay.
Push the modular bay latch away from the center of the computer. Keep
holding the latch open while pulling the device out of the modular bay with
the other hand.
$XGLR6KLHOG

1. Remove the back cover assembly.
2. Remove the keyboard assembly.
3. Remove the palmrest assembly.
4. Remove the 5-mm screw securing the audio shield (see Figure 22).
5. Remove the 5-mm screw securing the EMI drain wire.
6. Remove the audio shield.
NOTE: When you replace the audio shield, ensure that the audio shield is
properly seated to prevent it from cutting into the speaker wires or interfering
with devices installed in the modular bay. (You can check this by temporarily
installing a device in the modular bay prior to reinstalling the palmrest
assembly.)
latch lock