Dell Latitude CPi A - Manual (Page 42)

34 Dell Latitude CPiA Service Manual
b. Ensure that the plunger is inserted in its respective hole, that the side
of the slider with the two bumps is facing the rear of the case, and
that the surface with the wear ribs is facing the bottom of the case
(see Figure 25).
3. Snap in the new latch from the bottom of the base, making certain its snap
features are fully engaged in the slider.
4. Ensure that the newly installed latch moves smoothly and freely when
pushed and released.
5. Repeat steps 1 through 4 for the latch on the right side.
6. On the base plastic, find the molded label “P.N. ASSY 89501”; then use a
permanent marker to write “A01” to the right of “89501.”
This revision mark indicates that the latch rework is complete.
)LJXUH/HIW6OLGHU
6SHDNHUV
1. Remove the bottom case bracket.
2. If you are replacing the left speaker, carefully remove the speaker wires
from the retaining clips along the bracket’s edges.
3. Remove the speaker from the bottom case bracket.
NOTE: When you replace the speaker, follow these guidelines to prevent
damage to the speaker wires:
‡
Orient the speaker in the bottom case so that the speaker wires are facing
upwards.
‡
Route the speaker wires under their retaining clips on the bottom case
bracket.
bump side
wear ribs (2)