Service manual, Rqwhqwv, Recommended tools – Dell Latitude CPi A User Manual
Page 9: Preparing to work inside your computer, Screw identification and tightening, Zif connectors, Field-replaceable parts and assemblies, Removing field-replaceable parts and assemblies, Hard-disk drive assembly, Memory module cover
Dell Latitude CPiA Service Manual
1
'HOO/DWLWXGH&3L$
6HUYLFH0DQXDO
This manual provides instructions for removing and replacing
field-replaceable components, assemblies, and subassemblies in
your Dell Latitude portable computer. Unless otherwise noted,
each procedure in this chapter assumes the following:
The computer and any attached peripherals are turned off, and the
peripherals are disconnected from the input/output (I/O) panel on
the back of the computer.
A part can be replaced by performing the removal procedure in reverse
order.
When the display assembly is open nearly 180 degrees, use a book or
something similar to support it. The angle of the display assembly with
respect to the bottom case should never be allowed to exceed 180 degrees.
Also, when performing the procedures in this manual, the locations or
directions relative to the computer are as shown in Figure 1 unless
otherwise specified.
)LJXUH&RPSXWHU2ULHQWDWLRQ
right side
left side
back of computer
front of computer