Dell POWEREDGE M1000E - Manual (Page 18)

16 Dell 8/4Gbps FC SAN Module Hardware User’s Manual
53-1001964-01
Modify the FC SAN Module IP address
2
2. At the command prompt, type connect switch-x where x is the bay where the FC SAN Module is
installed. For example, switch-x can be:
• Switch-3 for FC SAN Module installed in bay B1.
• Switch-4 for FC SAN Module installed in bay B2.
• Switch-5 for FC SAN Module installed in bay C1.
• Switch-6 for FC SAN Module installed in bay C2.
3. At the login prompt, enter the default user name as “admin” and password as “password”.
4. Use the appropriate CLI commands to change the IP address of the selected FC SAN module.
Refer to your Blade Enclosure CLI documentation.
Using the CMC GUI to set the IP address
To change the IP address, use the following steps:
1. Open the CMC application’s Setup tab.
2. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate
and click Apply.
3. To enable DHCP, select DHCP Enabled and click Apply.
FIGURE 4 CMC Setup tab
NOTE
Refer to the application for additional detail.