Dell POWEREDGE M1000E - Manual (Page 29)

Dell 8/4Gbps FC SAN Module Hardware User’s Manual 27
53-1001964-01
Appendix
A
8/4Gbps FC SAN Module specifications
This appendix provides product specifications and regulatory compliance as a handy reference.
Default port mapping
The Dell 8/4Gbps FC SAN Module can contain 24 total ports. Of these, F_Ports are ports 1-16 and
N_Ports are ports 0 and 17-23.
The FC SAN Module is operates in NPIV mode only. In NPIV mode, the FC SAN Module F_Ports are
mapped to N_Ports. This following lists the factory-default F_Port to N_Port mapping for NPIV
mode. Since the FC SAN Module is shipped with Dynamic port licensing enabled, any out of the 24
ports can be enabled. Therefore this mapping applies for 12 active ports or, if a port upgrade
license is enabled, for 24 ports. For more information on changing port mapping and managing
ports in NPIV mode, refer to the Dell 8/4Gbps FC SAN Module Administrator's Guide.
• 17-23, 0 as N_Port with failover enabled, failback enabled
• 1, 2 mapped to 17
• 3, 4 mapped to 18
• 5, 6 mapped to 19·
• 7, 8 mapped to 20
• 9, 10 mapped to 21·
• 11, 12 mapped to 22·
• 13, 14 mapped to 23·
• 15, 16 mapped to 0
Processor and memory specifications
The processor and memory installed in the 8/4Gbps FC SAN Module are shown in Table 3 .
TABLE 3 Memory Specifications
Memory Type Value
PowerPC 440EPX processor 667 MHz
SDRAM 512 MB DDR2 - for system memory at 64 bits
wide with 8 ECC operating at 166 MHz
Boot flash 4 MB
Compact flash 512 MB