Hard drive, Removing a hard drive – Dell Dimension 4700 User Manual
Page 20
When connecting and disconnecting a serial ATA cable, hold the cable by the connector at each end.
Power Cable Connector
Hard Drive
1.
If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.
2.
Follow the procedures in "
Before You Begin
."
3.
Remove the computer cover
.
Removing a Hard Drive
1.
Disconnect the power and data cables from the drive and from the system board.
2.
Remove the hard drive bracket from the computer:
a.
Remove the bracket-securing screws for the hard drive.
b.
Remove the bracket for the hard drive from the computer.
NOTE:
The system board serial ATA connector may have an attached cover or shroud.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.