Clearing cmos settings – Dell Dimension 4700 User Manual
Page 44
Advertising
Clearing CMOS Settings
1.
Follow the procedures in "
Before You Begin
."
2.
Reset the current CMOS settings:
a.
Locate the 3-pin CMOS jumper (CLR CMOS) on the
system board
.
b.
Remove the jumper plug from pins 1 and 2.
c.
Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds.
d.
Replace the jumper plug on pins 1 and 2.
3.
Replace the computer cover
.
4.
Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in your Product Information Guide.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
Advertising