Dell Inspiron 8600 - Manual (Page 138)

138 Appendix
www
.dell.com | support.dell.com
3 Press the down-arrow key to select the Infrared Data Port setting, and press the right-
arrow key to change the setting to a COM port.
4 Press the down-arrow key to select the Infrared Mode setting, and press the right-
arrow key to change the setting to Fast IR or Slow IR.
It is recommended that you use Fast IR. If the infrared device cannot communicate
with your computer, shut down the computer and repeat steps 1 through 5 to change
the setting to Slow IR.
5 Press and then click Yes to save the changes and exit the system setup program.
If you are prompted to restart your computer, click Yes.
6 Follow the instructions on the screen.
7 After the infrared sensor has been enabled, click Yes to restart the computer.
After you enable the infrared sensor, you can use it to establish a link to an infrared device.
To set up and use an infrared device, see the infrared device documentation and the
Microsoft
® Windows ® Help and Support Center.
Dell Technical Support Policy (U.S. Only)
Technician-assisted technical support requires the cooperation and participation of the
customer in the troubleshooting process and provides for restoration of the operating
system, application software, and hardware drivers to the original default configuration as
shipped from Dell, as well as the verification of appropriate functionality of the computer
and all Dell-installed hardware. In addition to this technician-assisted technical support,
online technical support is available at support.dell.com. Additional technical support
options may be available for purchase.