Dell PowerEdge C5125 - Manual (Page 60)

60 Installing System Components
Installing 3.5" Hard-Drives
1 Connect the hard-drive cables to a new hard-drive. See Figure 3-11.
2 Place the hard-drive in the sled, lay the power and SATA cables in the sled,
then connect the power cables to the hard-drive board and the SATA
cables to the system board. See Figure 3-10.
3 Insert the hard-drive cables into the cable clips. See Figure 3-10.
4 Replace the hard-drive screws underneath the sled. See Figure 3-9.
Removing a Heat Sink
1 Remove the required sled from the system. See "Removing a Sled" on
page 50.
2 Loosen the four captive screws of the heat sink. Figure 3-12.
3 Remove the heat sink.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
WARNING: The heat sink may be hot to touch for some time after the system has
been powered down. Allow the heat sink to cool before removing it.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.