Dell XPS M1730 (M1730, Late 2007) - Manual (Page 150)

150
Adding and Replacing Parts
Turning Off Your Computer
NOTICE:
To avoid losing data, save and close any open files and exit any open
programs before you turn off your computer.
1 Shut down the operating system:
Windows
®
XP:
Click Start → Shut Down → Shut down.
Windows Vista™:
Click the Windows Vista Start button , click the arrow in the
lower-right corner of the Start menu as shown below, and then click
Shut Down.
The computer turns off after the operating system shutdown process
is complete.
2 Ensure that the computer and any attached devices are turned off. If your
computer and attached devices did not automatically turn off when you
shut down your operating system, press and hold the power button for at
least 8 to 10 seconds until the computer turns off.
Before Working Inside Your Computer
Use the following safety guidelines to help protect your computer from
potential damage and to help ensure your own personal safety.
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION:
Handle components and cards with care. Do not touch the components
or contacts on a card. Hold a card by its edges or by its metal mounting bracket.
Hold a component such as a processor by its edges, not by its pins.
NOTICE:
Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
NOTICE:
When you disconnect a cable, pull on its connector, not on the cable itself.
Some cables have a connector with locking tabs; if you are disconnecting this type
of cable, press in on the locking tabs before you disconnect the cable. As you pull
connectors apart, keep them evenly aligned to avoid bending any connector pins.
Also, before you connect a cable, ensure that both connectors are correctly
oriented and aligned.
book.book Page 150 Monday, April 14, 2008 4:23 PM