Dell Latitude Xpi CD - Manual (Page 70)

4-32 Dell Latitude XPi CD Service Manual
4. Lift the drive assembly straight up about 1 inch.
The front edge of the drive assembly engages tabs on the bottom case
assembly. Make sure the diskette drive assembly is clear of the tab before
attempting to lift it out of the bottom case assembly.
5. Disconnect the diskette drive and CD-ROM drive interface cables from
connectors JFLOP and JCDROM on the system board.
6. Lift the drive assembly out of the bottom case assembly.
When replacing the drive assembly, first connect the two drive interface cables
to the system board. Then lower the drive assembly into the bottom case assem-
bly, beginning with its forward edge, so that the diskette drive board fits
between the tabs in the corner of the bottom case assembly.
To separate the diskette/CD-ROM assembly into a diskette drive and a
CD-ROM drive, remove screws D3 through D9. Lift up the CD-ROM, and
remove it from the assembly. Slide the CD-ROM flex cable out of the slot in the
bracket that holds the CD-ROM to the diskette drive.
CAUTION: Before removing the diskette drive and CD-ROM drive
interface cables from connectors JFLOP and JCDROM, release each
connector’s plastic flip lock (see Figure 4-23). Do not pull the interface
cable from the connector; doing so can ruin the cable’s electrical
conductivity.
CAUTION: Use care when handling the diskette/CD-ROM drive; it is
fragile and will bend if handled improperly. Place the assembly on a flat
work surface, and carefully remove the small 2-mm screws. Do not bend
either the drives or the bracket. If bending occurs, the diskette or
CD-ROM will not function correctly when inserted in the drive.