Dell Latitude Xpi CD - Manual (Page 77)

Removing and Replacing Parts 4-39
Removing the System Board Assembly
To remove the system board assembly, follow these steps:
1. Remove the palmrest assembly.
2. Remove the display assembly.
3. Remove the diskette/CD-ROM assembly.
4. Verify that the PC Card ejectors are fully depressed.
5. Remove the deck buoy plate. (Reinstall this part on the new system
board.)
6. Remove the superpart assembly.
Carefully disengage the superpart docking EMI and serial EMI clips from
the I/O docking EMI and serial EMI clips.
7. Remove screws SB1 and SB2, which retain the system board (see
Figure 4-27).
8. Lift the system board approximately 2 inches from the back of the
computer.
9. Disengage the front of the system board from the three molded tabs in
the bottom case assembly.
The tabs’ approximate location is shown in Figure 4-27. The tabs are
located alongside the hard-disk drive compartment, inside the bottom case
assembly.
10. Lift the system board assembly out of the bottom case assembly.
NOTE: If the main battery insulator comes out with the system board assem-
bly, detach the insulator and set it aside.
CAUTION: To ensure maximum cooling for the microprocessor, do
not touch the heat transfer area on the system board above the micro-
processor or on the deck buoy plate. The oils in your skin reduce the
heat transfer of the thermal pads.
CAUTION: When removing the system board assembly, be careful
not to damage the main battery connector and EMI shield on the bot-
tom of the assembly.