Replacing drives, Removing the hard drive, Installing the hard drive – Dell Studio Hybrid D140G (Mid 2008) User Manual
Page 17
Back to Contents Page
Replacing Drives
Dell™ Studio Hybrid Service Manual
Your computer supports:
l
One externally accessible SATA device (optical drive)
l
One internally accessible SATA device (hard drive)
Removing the Hard Drive
1.
Follow the procedure in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive cage (see
Removing the Drive Cage
).
4.
Remove the four screws that secure the hard drive to the drive cage. Turn the drive cage over and slide the hard drive towards the front of the drive
cage.
5.
Hold the hard drive on either side while removing the hard drive.
Installing the Hard Drive
1.
Follow the procedure in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive cage (see
Removing the Drive Cage
).
4.
Remove the existing hard drive, if applicable (see
5.
Prepare the new hard drive for installation and check the documentation for the hard drive to verify that the hard drive is configured for your computer.
6.
Verify that the hard-drive bay is empty and unobstructed.
7.
Hold the hard drive on either side and slide the hard drive into the hard- drive bay until it clicks securely into place.
8.
Secure the hard drive to the drive cage by replacing the four screws.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
If you are replacing a hard drive that contains important data, back up your files before you begin this procedure.
NOTICE:
The connectors are keyed to ensure correct insertion. Use of excessive force may damage the connectors.