Replacing the back i/o board, Removing the back i/o board, Installing the back i/o board – Dell Studio Hybrid D140G (Mid 2008) User Manual
Page 2
Back to Contents Page
Replacing the Back I/O Board
Dell™ Studio Hybrid Service Manual
Removing the Back I/O Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive cage (see
Removing the Drive Cage)
.
4.
Disconnect the flex cable from the I/O board.
5.
Remove the two screws that secure the I/O board to the back panel.
6.
Gently lift the I/O board away from the back panel.
Installing the Back I/O Board
1.
Align the connectors on the I/O board to the slots in the back panel.
2.
Replace the two screws and secure the I/O board to the back panel.
3.
Reconnect the flex cable to the I/O board.
4.
Replace the drive cage (see
Installing the Drive Cage
).
5.
Replace the computer cover (see
Installing the Computer Cover
).
Back to Contents Page
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
Ensure that you remove all cables out of the way before replacing the drive cage.