Dell Studio Hybrid D140G (Mid 2008) User Manual
Page 24
Back to Contents Page
Replacing Memory Module(s)
Dell™ Studio Hybrid Service Manual
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on the
memory supported by your computer. Install only memory modules intended for your computer.
Your computer has two user-accessible SO-DIMM sockets located one below the other.
Removing Memory Module(s)
1.
Follow the procedure in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive cage (see
Removing the Drive Cage
).
4.
To locate the memory modules, (see
Inside View of Your Computer
).
5.
Push apart the securing clips until the module pops up.
6.
Remove the module from the slot.
Installing Memory Module(s)
1.
Follow the procedure in
Before You Begin
.
2.
Align the notch in the module edge connector with the tab in the connector slot.
3.
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If it is not firmly seated, remove the
module and reinstall it.
4.
Replace the drive cage (see
Installing the Drive Cage
).
5.
Replace the computer cover (see
Installing the Computer Cover
).
6.
Connect your computer and devices to electrical outlets, and then turn them on.
7.
When the message appears stating the memory size has changed, press <F1> to continue.
8.
Log on to your computer.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
Memory purchased from Dell™ is covered under your computer warranty.
1
securing clips
2
memory modules
NOTICE:
If the memory module is not installed properly, the computer may not boot.