Bluetooth board, Removing the bluetooth board – Dell Inspiron 1546 (Late 2009) User Manual
Page 10
1.
Follow the procedures in
Before You Begin
.
2.
Connect the Bluetooth card to the connector on the Bluetooth board.
3.
Replace the screw that secures the Bluetooth card to the Bluetooth board.
4.
Replace the keyboard (see
Replacing the Keyboard
).
5.
Replace the center control cover (see
Replacing the Center Control Cover
).
6.
Replace the hard drive (see
Replacing the Hard Drive
).
7.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
8.
Replace the module cover (see
Replacing the Module Cover
).
9.
Replace the battery (see
Replacing the Battery
).
Bluetooth Board
Removing the Bluetooth Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the module cover (see
Removing the Module Cover
).
4.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
5.
Remove the hard drive (see
Removing the Hard Drive
).
6.
Remove the center control cover (see
Removing the Center Control Cover
).
7.
Remove the keyboard (see
Removing the Keyboard
).
8.
Remove the Bluetooth card (see
).
9.
Disconnect the Bluetooth board cable from the system board connector and remove it from the routing guide.
10.
Using a plastic scribe, pry out the Bluetooth board to release it from the palm rest.
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The Bluetooth board is glued to the palm rest. Do not pull on the Bluetooth board cable to remove the Bluetooth board.