Display bezel, Replacing the display assembly, Removing the display bezel – Dell Inspiron 1546 (Late 2009) User Manual
Page 26
Replacing the Display Assembly
1.
Follow the procedures in
Before You Begin
.
2.
Place the display assembly in position and replace the four screws that secure the display assembly to the computer base.
3.
Route the display cable and camera cable into their routing guides and connect the cables to the respective system board connectors.
4.
Route the Mini-Card antenna cables, and guide the cables to the bottom of the computer through the cable routing slot.
5.
Replace the keyboard (see
Replacing the Keyboard
).
6.
Replace the center control cover (see
Replacing the Center Control Cover
).
7.
Replace the two screws at the bottom of the computer.
8.
Route the Mini-Card antenna cables through the routing guides at the bottom of the computer, and replace the Mini-Card (see
Replacing the Mini-Card
).
9.
Replace the hard drive (see
Replacing the Hard Drive
).
10.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
11.
Replace the module cover (see
Replacing the Module Cover
).
12.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1
display assembly
2
screws (4)
3
display cable connector
4
camera cable connector
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.