Camera module (optional), Removing the camera module, Replacing the camera module – Dell Inspiron 1546 (Late 2009) User Manual
Page 12
Back to Contents Page
Camera Module (Optional)
Dell™ Inspiron™ 1546 Service Manual
Removing the Camera Module
1.
Follow the procedures in
Before You Begin
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Remove the display panel (see
Removing the Display Panel
).
5.
Disconnect the camera cable from the connector on the camera module.
6.
Remove the two screws that secure the camera module to the display cover.
7.
Remove the camera module.
Replacing the Camera Module
1.
Follow the procedures in
Before You Begin
.
2.
Replace the two screws that secure the camera module to the display cover.
3.
Connect the camera cable to the connector on the camera module.
4.
Replace the display panel (see
Replacing the Display Panel
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
screws (2)
2
camera module
3
camera cable connector