Dell 1100 Laser Mono Printer - Manual (Page 71)

LED Pattern Meaning and Suggested Solution
Your printer has some problems. If this problem occurs, contact your service representative.
• A paper jam has occurred. To solve the problem, see "Clearing Jams in the Paper Tray" .
• The front cover is open. Close the front cover.
• The top cover is open. Close the top cover.
• The paper tray is empty. Load paper in the tray. See "Loading Paper" .
• A toner cartridge is not installed. Install a toner cartridge. See "Installing the Starter Toner
Cartridge" .
• If the printer is receiving data, blinks green slowly.
• If the printer is printing received data, blinks green quickly.
• You pressed
while the printer was receiving data.
• In Manual Duplex mode, the first side of your job has printed. Load the paper back into the tray and
press t o start printing. For details, see "Printing on Both Sides of Paper (Manual Duplex)" .
You print in 600dpi resolution and your printer does not have enough memory to print the current job.
When the Printing Status window appears, select one of the following options.
• Click Cancel . An Internal error sheet prints and the current job automatically clears. Try simplifying
the page layout and removing unnecessary graphics from your document.
• Click Print . Your printer prints the current job in 300 dpi resolution. If a memory shortage occurs
again, the Printing Status window will appear again and an Internal error sheet will print. The current
job automatically clears. Try simplifying the page layout and removing unnecessary graphics from
your document.
In Manual Feed mode, there is no paper in the paper tray. Load paper into the tray and press to
start printing.
The toner cartridge is nearly empty. Redistribute the toner to temporarily extend the life of the toner
cartridge. If this does not improve print quality, install a new toner cartridge. See "Replacing the Toner
Cartridge" .
Troubleshooting Checklist
If the printer is not working properly, consult the following checklist. If the printer does not pass a step,
follow the corresponding troubleshooting suggestions.