Dell Inspiron 15 (N5040, Mid 2011) - Manual (Page 44)

44 USB Board
Replacing the USB Board
1 Follow the procedures in "Before You Begin" on page 9.
2 Slide the connectors on the USB board into the slots on the computer base
and snap the USB board into place.
3 Slide the USB-board cable into the connector on the USB board. Press
down on the connector latch to secure the USB-board cable to the
connector on the USB board.
4 Replace the hard drive (see "Replacing the Hard Drive" on page 39).
5 Follow the instructions from step 3 to step 7 in "Replacing the Palm-Rest
Assembly" on page 32.
6 Replace the battery (see "Replacing the Battery" on page 14).
CAUTION: Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
1 USB-board cable 2 USB board
3 tabs (2)
1 2
3