Dell Inspiron 15 (N5040, Mid 2011) - Manual (Page 65)

Display 65
Replacing the Display Panel
1 Follow the instructions in "Before You Begin" on page 9.
2 Attach the display cable to the back of the display panel.
3 Connect the display cable to the display-board connector and secure it
with the tape.
4 Align the screw holes on the display bracket with the screw holes on the
display panel and replace the four screws (two on each side).
5 Route the display cable and Mini-Card antenna cables through the routing
guides on the display hinges.
6 Align the screw holes on the display panel with the screw holes on the
display cover and replace the six screws.
7 Replace the display bezel (see "Replacing the Display Bezel" on page 62).
8 Replace the display assembly (see "Replacing the Display Assembly" on
page 60).
CAUTION: Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
1 tape 2 display-board connector
3 display cable
1
2
3