System board connectors, Table a – Dell PowerEdge 2850 User Manual
Page 3
Advertising
Table A-1. System Board Jumper Settings
System Board Connectors
for the location and description of system board connectors.
Figure A-3. System Board Connectors
Jumper
Setting
Description
PASSWD
(default)
The password feature is enabled.
The password feature is disabled.
NVRAM_CLR
(default)
The configuration settings are retained at system boot.
The configuration settings are cleared at the next system boot. (If the configuration settings become corrupted to the point
where the system will not boot, install the jumper and boot the system. Remove the jumper before restoring the configuration
information.)
NOTE:
For the full name of an abbreviation or acronym used in this table, see the "Glossary" in the User's Guide.
Advertising