Dell XPS 400/Dimension 9150 User Manual
Page 31
Advertising
System Setup: Dell XPS 400 Service Manual
file:///T|/htdocs/systems/xps400/sm/syssetup.htm[8/3/2012 3:11:21 PM]
a. Locate the 3-pin CMOS jumper (RTCRST) on the system board (see "
").
b. Remove the jumper plug from pins 1 and 2.
c. Place the jumper plug on pins 2 and 3 and wait approximately five seconds.
d. Replace the jumper plug on pins 1 and 2.
.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
4. Connect your computer and devices to electrical outlets, and turn them on.
Advertising