Hinged stand, Removing the hinged stand, Replacing the hinged stand – Dell Vostro 320 (Mid 2009) User Manual
Page 15
Back to Contents Page
Hinged Stand
Dell™ Vostro™ 320 Service Manual
Removing the Hinged Stand
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com to view the following illustrations.
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
I/O cover
.
3.
Lift the stand up as far as it goes to reveal the screws that secure the stand to the computer chassis.
4.
Remove the screws that secure the stand to the computer.
5.
Tilt down the hinged stand again.
6.
Remove the hinged stand from the computer.
Replacing the Hinged Stand
To replace the hinged stand, perform the above steps in the reverse order.
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.