Display assembly, Removing the display panel, Replacing the display panel – Dell Vostro 320 (Mid 2009) User Manual
Page 35: Removing the display cable, Replacing the display cable
Back to Contents Page
Display Assembly
Dell™ Vostro™ 320 Service Manual
Removing the Display Panel
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com to view the following illustrations.
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
front panel
.
3.
Remove the
internal panel
.
4.
Remove the
I/O cover
.
5.
Remove the
hinged stand
.
6.
Remove the
optical drive
.
7.
Remove the
back cover
.
8.
Remove the
back metal-shielding
.
9.
Remove the
system-board shielding
.
10.
Remove the
wireless local area network (WLAN) card
.
11.
Remove the
memory module
.
12.
Remove the
heat sink
.
13.
Remove the
processor
.
14.
Remove the
system board
.
15.
Remove the screws that secure the display panel to the computer chassis.
16.
Carefully remove the display panel from the computer. Ensure that you do not damage the cables while removing the display panel from the computer
chassis.
Replacing the Display Panel
To replace the display panel, perform the above steps in reverse order.
Removing the Display Cable
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
display panel
.
3.
Release the tape that secures the display cable to the display-panel connector.
4.
Press the securing clips on either side of the display-panel connector, and then pull the cable straight out to remove the cable.
Replacing the Display Cable
To replace the display cable, perform the above steps in reverse order.
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.