Dell OptiPlex 390 (Mid 2011) - Manual (Page 78)

Error Message Description
Bad command or file name Ensure that you have spelled the
command correctly, put spaces in the
proper place, and used the correct path
name.
Bad error-correction code (ECC) on disk
read
The hard drive controller detected an
uncorrectable read error.
Controller has failed The hard drive or the associated controller
is defective.
Data error The hard drive cannot read the data. For
the Windows operating system, run the
chkdsk utility to check the file structure of
the hard drive. For any other operating
system, run the appropriate corresponding
utility.
Decreasing available memory One or more memory modules may be
faulty or improperly seated. Re-install the
memory modules and, if necessary,
replace them.
Gate A20 failure One or more memory modules may be
faulty or improperly seated. Reinstall the
memory modules and, if necessary,
replace them.
General failure The operating system is unable to carry
out the command. This message is usually
followed by specific information—for
example, Printer out of paper. Take the
appropriate action to resolve the problem.
Hard-disk drive configuration error The hard drive failed initialization.
Hard-disk drive controller failure The hard drive failed initialization.
Hard-disk drive failure The hard drive failed initialization.
Hard-disk drive read failure The hard drive failed initialization.
Invalid configuration information-please
run SETUP program
The computer configuration information
does not match the hardware
configuration.
Invalid Memory configuration, please
populate DIMM1
DIMM1 slot does not recognize a memory
module. The module should be re-seated
or installed.
78