Dell Dimension 2100 - Manual (Page 73)

A d d i n g Pa r t s 73
13 Replace the front panel.
Fit the front panel’s two retaining hooks into their corresponding slots
on the computer (see page 68). Then, rotate the front panel toward
the computer until the front panel latches into position.
14 Make sure that no cable connections were loosened during the
procedure. Arrange cables so that they will not interfere with replacing
the power supply and computer cover.
15 Rotate the power supply back into place (see page 64).
16 Replace the computer cover (see page 80).
17 Plug your computer and devices into their electrical outlets, and turn
them on.
18 See the drive’s documentation for instructions on installing any
software required for drive operation.
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
To install a card:
1 Turn off the computer and devices, and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network jack on the wall.
2 Press the power button.
Pressing the power button when the computer is not connected to an
electrical outlet discharges residual electricity and can help prevent
system board damage.
3 Remove the computer cover (see page 60).
4 Rotate the power supply (see page 62).