Dell Dimension 2100 - Manual (Page 78)

78 A d d i n g Pa r t s
www
.dell.com | support.dell.com
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
HINT: Memory
purchased from Dell is
covered under your
computer warranty.
You can increase your computer memory by installing memory modules on
the system board. See page 83 for information on the type of memory
supported by your computer.
1 Turn off the computer and devices, and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network jack on the wall.
2 Press the power button.
Pressing the power button when the computer is not connected to an
electrical outlet discharges residual electricity and can help prevent
system board damage.
3 Open the computer cover (see page 60).
4 Rotate the power supply (see page 62).
5 If necessary, remove a memory module:
a Press out the securing clip at each end of the memory connector.
b Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back
and forth to remove it from the connector.