Replacing the i/o panel – Dell Precision 490 User Manual
Page 116
6.
If the system is in tower mode, pull to remove the full-length card retainer piece beside the card fan.
7.
Press the tab between the card fan and the front fan towards the card fan as you lift it up and out of the computer.
8.
Note the routing of each cable as you disconnect all cables attached to the I/O panel.
9.
Remove the mounting screw from the I/O panel.
10.
Remove the I/O panel from the computer.
Replacing the I/O Panel
Follow
1 card fan
2 card fan cable
3 card fan system-board connector (FAN_CCAG)
4 front fan
5 full-length card retainer piece
NOTICE:
Carefully note the routing of each cable before you disconnect it, so that you are sure to re-route cables correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
1 I/O panel
2 mounting screw
NOTICE:
Ensure that you replace all cables originally attached to the I/O panel or you may experience computer problems.