Dell Precision 490 User Manual
Page 60
12.
Shields Present in Some Drive Configurations
a.
Insert the metal insert's two upper screws and its two lower screws into the corresponding slots inside the FlexBay.
b.
Push the vented metal insert until it clicks into place and its metal tabs rest flush against the chassis surface.
13.
Reinstall the drive panel (see
14.
Ensure that all connectors are properly cabled and firmly seated.
15.
Replace the computer cover (see
Replacing the Computer Cover
).
16.
Connect the computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
17.
If the drive you just installed is the primary drive, insert bootable media into drive A.
18.
Turn on the computer.
19.
Enter the system setup program (see
System Setup
) and update the appropriate Drive option.
20.
Exit the system setup program, and reboot the computer.
21.
Partition and logically format your drive before you proceed to the next step.
See the documentation for your operating system for instructions.
22.
Test the hard drive. See
Dell Diagnostics
for instructions.
23.
If the drive you just installed is the primary drive, install your operating system on the hard drive.
Removing an Optional SATA Third Hard Drive (Desktop Computer Only)
1 SAS data cable 4 SAS connector
2 power cable
5 optional SAS controller card
3 power supply 6 optional SAS hard drive in FlexBay
NOTICE:
If metal shields are present in your computer configuration, they must be installed at all times while your computer is in use or your computer
may not function properly.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.