Dell XPS M1530 (M1530, Late 2007) - Manual (Page 43)

Communication Cards 43
4 Ground yourself by touching one of the metal connectors on the back of
the computer.
NOTE: If you leave the area, ground yourself again when you return to the computer.
5 Remove the M2 x 3-mm securing screw.
NOTE: In case of an UWB card, disconnect the blue antenna cable from the UWB
card.
6 Remove the FCM or UWB card.
Replacing the FCM or UWB
NOTICE: Install the FCM or UWB in the WWAN or WPAN slot. Do not install an
FCM or UWB in the WLAN card slot. Doing so may cause damage to your computer.
1 Insert the FCM or UWB connector at a 45-degree angle into the system
board connector labeled "FCM" or "UWB."
2 Press the other end of the FCM or UWB down into the slot on the system
board until the card clicks into place.
3 Replace the M2 x 3-mm securing screw.
NOTE: In case of an UWB card, reconnect the blue antenna cable to the UWB
card.
1 FCM card 2 M2 x 3-mm securing screw
2
1